You’ll also need a Text-to-Speech (TTS) and a Speech-to-Text (STT) engine. To install them: yaourt -S jasper-voice-control-git If you’re using ArchLinux, there are packages available in the Arch User Repository. Unfortunately, there are currently no packages available for Debian or Raspbian. Method 2: Installation via Package Manger Debian/Raspbian If you want to understand how all of the supporting libraries are compiled on the Raspberry Pi, Method 3 may be to your liking (or, at the very least, helpful for debugging). After imaging your SD card, clone the repository and install the Python dependencies as described in Install Jasper. There is also an unofficial image for the B+ available here. The quickest way to get up and running with Jasper is to download the pre-compiled disk image available here for Model B. Was the console working before you started : Yĭo you get a green debug light appear on the RGH chip every 4-5 seconds : Yįor some reason, Im getting two video windows even though I placed one video link.There are three ways to install Jasper on your Raspberry Pi. Images of close-up soldering to motherboard :įailing to get into xell, console boots fine when CLK or CPU_RST is disconnected from the glitch chip. Screenshot of NAND details from J-Runner / Xebuild GUI : nothing special there, retail nand. Glitch/Nand Reader Product(s) used : J-R Programmer, CR3 Rev C (Clone I believe) Otherwise, it boots normally when either one of them is disconnected from the glitch board. At last, I flashed back the original nand dump, it gives RROD (0022) in 3-4 seconds when both CPU_RST or CLK are connected to the glitcher. Ive followed all the common practices, etc trimming the wires and wire paths. I'm facing a problem as illustrated in the video link below (trying to boot xell), I tried both CLK points (the on top and the bottom of the board) with no luck.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |